Ip Ospf Cost Command; Interface Mode; Ip Ospf Hello-Interval Command; Ip Ospf Dead-Interval Command - Avaya P334T-ML User Manual

Chapter 7 CLI – Layer 3

Interface Mode

ip ospf cost Command

Use the ip ospf cost command to configure interface metric. The no form of
this command sets the cost to its default. The default is 1.
The syntax for this command is:
[no] ip ospf cost <cost>
cost
Example:
ip ospf cost 10

ip ospf hello-interval Command

Use the ip ospf hello-interval command to specify the time interval
between hello's the router sends. The no form of this command sets the hello-
interval to its default. The default is 10.
The syntax for this command is:
[no] ip ospf hello-interval <seconds>
seconds
Example:
ip ospf hello-interval 5

ip ospf dead-interval Command

Use the ip ospf dead-interval command to configure the interval before
declaring the neighbor as dead. The no form of this command sets the dead-
interval to its default. The default is 40.
The syntax for this command is:
[no] ip ospf dead-interval <seconds>
seconds
Example:
ip ospf dead-interval 15
188
integer
integer
integer
P334T-ML User's Guide