Evaluation With Difference Values; Entering 2 Limits By Weighing - KERN FES 33K0.1 IPM Operating Instruction

12.5 Evaluation with difference values

12.5.1

Entering 2 limits by weighing

Important information!
Always begin by entering the lower limit value, followed by the upper limit value.
Enter.
Operation
1. Tolerance weighing function
[2.SEL.2] or [2.SEL.3] (see chapter
7).
2. Actuate required parameter selection
or
until
[23. P .2] or [24.
1
more settings of your choice (see chap.
12.3) are carried out in the same way
3. Leave function menu
FES/FEJ-BA-e-1132
Parameter selection for 2 limiting points:
TXP.2] appears;
Parameter selection for difference value:
The balance is now in tolerance weigh-
ing mode; the tolerance marker ( ) ap-
pears
Display
r SEL 2
2q CQ. 1
2s P . 2
1
2t TXP. 2
a
z0
g
67