Initial Commissioning; Power Display - KERN FES 33K0.1 IPM Operating Instruction

6.8 Initial Commissioning

In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. 1). During this warm-
ing up time, the balance must be connected to the power supply (mains, accumulator
or battery).
The accuracy of the balance depends on the local acceleration of gravity.
Please be sure to observe the information in the chapter on adjusting in chap. 6.8.
6.8.1

Power display

The balance will carry out a self-test
a
Stand-by
18
Supply balance with power via the
mains power supply.
Balance is in stand-by mode (green
LED is on).
Use the
ance on.
If there is an object on the weighing
plate when the balance is switched
on there is a flashing display „on
0". In that case, remove object
from the weighing plate.
By pressing lightly it is possible to
check whether the balance display
changes.
z0
g
75s0
g
Use the
ance off. The balance is now in
stand-by mode again (green LED is
on).
-key to switch the bal-
-key to switch the bal-
FES/FEJ-BA-e-1132