KERN FES 33K0.1 IPM Operating Instruction page 69

7. Place sample for the first limiting
value on the weighing plate:
8. Save
9. Place sample for the upper (i.e. lar-
ger) limiting value on the weighing
plate:
10. Save
Remove sample from weighing plate.
The balance returns to tolerance weigh-
ing mode.
From here evaluation takes place
whether the goods to be weighed are
within the two tolerance limits.
* If you want to set for your tolerance weighing only one limit point
(parameter selection [23.
FES/FEJ-BA-e-1132
An acoustic signal sounds, the saved
lower difference value is briefly dis-
played.
The flashing display (last saved value)
prompts you to enter the upper limiting
value
An acoustic signal sounds, the saved
upper difference value is briefly dis-
played.
)
, the input herewith is finished.
P .1]
1
H. SET
K
69