Reset To Factory Settings - Leica 3D Disto User Manual

Adjustment step-
by-step
8.5
Reset to factory
settings step-by-
step
1.800.561.8187 3D Disto, Check & Adjust
Step Description
1. Set up the 3D Disto close to a wall with a steep target of good visibility that
is at least 15 m above the instrument.
3D Disto_051
2. Calibration is started in Menu » Device » Calibration.
3.
Press .
Pointfinder opens
4.
Target as precisely as possible.
5.
Press .
3D Disto turns to second face automatically.
6.
Target a second time. Press
7. If both measurements were successful, a pop-up window appears with Set
new: XXX gon, Reset to factory default, or Cancel calibration.
8. Choose Set... or Reset... to adjust V-index.
9. Final pop-up asks Are you sure? Yes/Cancel. If Yes, checkmark is displayed
to confirm parameters were set successfully.

Reset to Factory Settings

Step Description
1. Calibration is started in Menu » Device » Calibration.
2.
Press .
Pop-up appears Reset all calibration settings to factory default? Yes/No.
3. If Yes: all user-defined calibration settings are reset to factory default
without further request.
www.
.
.
.com
information@itm.com
65