Location; Information@Itm.com - Leica 3D Disto User Manual

6.4
Description
Secure Location
step-by-step
Relocation step-by-
step
1.800.561.8187 3D Disto, Software Applications

Location

The Location functions allow to change the position of the 3D Disto.
Secure Points are placed by the user and make the positioning procedure easy.
Step Description

You have to measure two points first before Secure Points can be saved.
1. Label and affix three to five self-adhesive target marks on walls, ceiling or
floor around your working area. Ensure that the target marks are spread out.
2. Press Menu » Applications » Location » Secure Location.
Pointfinder opens.
3.
Target the Target marks as precisely as possible and press
3D Disto takes a photo and saves it with coordinates, labelled with ID and
date.
4. Pop-up prompts Measure more Secure Points? Yes/No.
5. Proceed as before and measure at least three Secure Points.

You can add more Secure Points at any time.

Ensure you have enough well-measured Secure Points around your working
area. Even if one is lost there must be at least three for a successful reloca-
tion.
6. After saving a minimum of three points you may leave the application by
choosing No.
This feature allows the relocation of the 3D Disto into a defined coordinate system
previously established by the Secure Location procedure, for example to complete a
previous measurement.
Step Description

Use a 3D Disto position that allows targeting and measuring at least three
Secure Points around your working area.
1. Press Menu » Applications » Location » Relocate.
A pop-up prompts you to define the tolerance.
2.
Press OK to confirm the value.
www.

information@itm.com

.com
to measure.
55