Leica 3D Disto User Manual page 56

1.800.561.8187 3D Disto, Software Applications
Step Description

A lower tolerance increases the accuracy of your measurements and requires
precise aiming and visibility of the Secure Points.

If there are no Secure Points available but your measurement must fit to the
geometry of a previous one, just start your measurement with the same Base
Line points. These are the first two points of a measurement.
If Secure Points are available, folder opens.
3.
Choose a Secure Point by pressing
Press to enlarge.
Press to see all Secure Points of the whole memory.
4.
Press to confirm point.
Pointfinder opens.
5. Target the target mark shown in the photo as precisely as possible and press
to measure.
If successful, pop-up appears Measure next Secure Point? Yes/Cancel.
6. If Yes: Folder opens to choose next Secure Point.
Proceed as described previously for the second and third Secure Point.

If the first two Secure Points were measured successfully the 3D Disto
roughly turns to the next chosen Secure Point. You just have to do the fine
targeting and press
7. When you have measured three points successfully a pow-up shows OK.
Measure more Secure Points? Yes/No/Cancel.
• Press Yes to continue and proceed as described previously.
• Press No to finish.
If successful, a pop-up displays the dimensions between old and new posi-
tion: XXXm; Height: XXXm; OK/Cancel. Accept with OK or Cancel to
measure further points.
If Relocation was not successful, pop-up prompts Out of tolerance!
Measure more Secure Points? Yes/No/Cancel. Go on as described previ-
ously.
8.
Press to close the application.
www.
/
.
information@itm.com
.com
or by tapping on the screen.
56