Yamaha SR400 2014 Service Manual page 83

1. Air cut-off valve
2. Air induction system hose (air filter case–air cut-off
valve)
3. Air induction system hose (air cut-off valve–air
induction system pipe)
4. Air induction system pipe
A. Point the end of the clamp downward.
B. A 0 to 5 mm (0 to 0.2 in) gap is allowed to be pres-
ent between the air induction system hose and the
air filter case.
C. Insert the air induction system hose (air filter
case–air cut-off valve) into the base of the air
cut-off valve.
D. Point the end of the clamp to the inside.
E. Point the end of the clamp obliquely downward.
F. 60
G. 30
H. Clamp installation range
I. Install the air induction system hose (air cut-off
valve–air induction system pipe) so that the white
paint mark faces outward.
J. 2.0–6.0 mm (0.08–0.24 in)
K. 23.0 mm (0.91 in)
2-56
CABLE ROUTING