Yamaha SR400 2014 Service Manual page 109

3
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
7. Install:
• Oil drain bolt gasket
• Oil drain bolt (oil tank side) "1"
Oil drain bolt
16 Nm (1.6 m·kgf, 12 ft·lbf)
1
• Oil drain bolt gasket
• Oil drain bolt (crankcase side) "2"
Oil drain bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
8. Fill:
• Oil tank
(with the specified amount of the recom-
mended engine oil)
2
New
New
2
PERIODIC MAINTENANCE
Engine oil quantity
Quantity (disassembled)
2.40 L (2.54 US qt, 2.11 Imp.qt)
Without oil filter element replace-
ment
2.00 L (2.11 US qt, 1.76 Imp.qt)
With oil filter element replace-
ment
2.10 L (2.22 US qt, 1.85 Imp.qt)
9. Install:
• Engine oil level gauge
10.Start the engine, warm it up for several min-
utes, and then turn it off. Before checking the
engine oil level, wait a few minutes until the oil
has settled.
11.Check:
• Engine
(for engine oil leaks)
12.Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL" on page 3-21.
13.Check:
• Engine oil pressure
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Slightly loosen the oil check bolt "1".
ECA2RD1002
NOTICE
Engine start-up with the oil check bolt re-
moved will cause an oil spout. Check with
the oil check bolt loosened without fail.
1
b. Start the engine and check to see if oil seeps
out while idling the engine for about one min-
ute.
ECA2RD1003
NOTICE
Any inspection must be conducted at engine
idling speed. Do not rev up the engine.
c. If no oil seeps out, check the engine oil pas-
sages, the oil filter element and the oil pump
for damage or leakage.
3-23