EAS23110
REMOVING THE LOWER BRACKET
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Upper ring nut
• Lower ring nut
TIP
Remove the ring nut "2" with the ring nut wrench
"1".
Ring nut wrench
90890-01268
Spanner wrench
YU-01268
EWA13730
WARNING
Securely support the lower bracket so that
there is no danger of it falling.
1
EAS23120
CHECKING THE STEERING HEAD
1. Wash:
• Bearing
• Bearing race
Recommended cleaning solvent
Kerosene
2. Check:
• Bearing "1"
• Bearing race "2"
Damage/pitting Replace.
3. Replace:
• Bearing
• Bearing race
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the bearing races from the steering
head pipe "1" with a long rod "2" and hammer.
b. Remove the bearing races "3" from the lower
bracket with a floor chisel "4" and hammer.
c. Install new dust seals and new bearing races.
ECA14270
NOTICE
If the bearing race is not installed properly,
the steering head pipe could be damaged.
TIP
• Always replace the bearings and bearing races
as a set.
2
• Whenever the steering head is disassembled,
replace the dust seal.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4. Check:
• Upper bracket
4-46
STEERING HEAD
2
1
2