Yamaha SR400 2014 Service Manual page 71

1. Meter lead
2. Clutch switch lead
3. Headlight coupler
4. Left handlebar switch lead
5. Front left turn signal light lead
6. Main switch lead
7. Auxiliary light lead
8. Front right turn signal light lead
9. Right handlebar switch lead
10. Front brake light switch lead
11. Clamp
A. 50–60 mm (1.97–2.36 in)
B. Fasten the meter lead (speedometer), main switch
lead, and clutch switch lead with the clamp.
C. Route the front left turn signal light lead inside of
the headlight through the rear of the speedometer
cable.
D. Route the front right turn signal light lead inside of
the headlight through the rear of the tachometer
cable.
E. Fasten the meter lead (tachometer), main switch
lead, front brake light switch lead, right handlebar
switch lead, and clutch switch lead with the clamp.
F. Over 20 mm (0.79 in) away from the end
G. Point the open end of the clamp forward.
H. Harness coming into the inside of the headlight
I. Route the right handlebar switch lead, front brake
light switch lead, and meter lead (speedometer
and tachometer).
J. Route the left handlebar switch lead, front left turn
signal light lead, main switch lead, and clutch
switch lead.
K. Route the wire harness and front right turn signal
light lead.
2-44
CABLE ROUTING