Yamaha SR400 2014 Service Manual page 63

1. Speedometer cable
2. Clutch cable
3. Decompression cable
4. Left handlebar switch lead
5. Ignition coil
6. Wire harness
7. Spark plug lead
8. Throttle cable (decelerator)
9. Throttle cable (accelerator)
10. Engine temperature sensor
11. Fuel tank breather hose
12. Ground lead
A. Route the speedometer cable to the inside of the
front fork.
B. Fasten the wire harness to the frame with the
T-stud.
C. Fasten the ground lead and throttle cable guide.
D. Pass only the throttle cables through the guide.
E. Silicon solution or soap water may be applied
when a boot is installed to the clutch cable.
F. Fasten with the clamp at an area where no fuel
tank breather hose protector is mounted.
G. Pass the clutch cable through the engine mount
guide.
H. Route the wire harness to the inside of the spark
plug lead.
I. Route the wire harness and throttle cable above
the tank stopper.
J. Pass the speedometer cable through the front
fender guide.
K. Install the ignition coil damper at the vehicle front
so that the bent portion points downward.
L. Point the ground lead forward and crimped side
toward the inside.
M. Install the guide to point downward.
2-36
CABLE ROUTING