Yamaha SR400 2014 Service Manual page 77

1. Fuel tank
2. Pump case breather hose (fuel pump case–fuel
tank)
3. Fuel pump case
4. Fuel hose (fuel pump–fuel rail)
5. Fuel hose (fuel tank–fuel pump case)
6. Fuel cock
7. Fuel pump case box
A. Insert the pump case breather hose (fuel pump
case–fuel tank) to the base of the fuel tank pipe.
B. Install the pump case breather hose (fuel pump
case–fuel tank) so that its paint mark is located at
the left side of the vehicle. Install so that an end of
the clamp overlaps the paint mark and point the
open end rearward.
C. The protector end of the fuel hose should be
located below the grommet.
D. Point the open end of the clamp to the inside.
E. Point the end of the clamp downward.
F. Detailed clamp installation
G. Install a clamp halfway between the hose end and
the bulge of a pipe end.
H. Point the end of the clamp to the left.
I. Insert the pump case breather hose (fuel pump
case–fuel tank) into the end of the round portion at
the fuel pump case.
J. Insert the fuel hose (fuel tank–fuel pump case)
into the base of the fuel pump case pipe.
K. Make sure that the fuel hose is not inverted when
installed.
L. 29 mm (1.14 in)
M. Route the fuel hose (fuel tank–fuel pump case)
between the coupler cover and the key cylinder.
N. Install the fuel hose (fuel pump–fuel rail) to the
guide of the fuel pump case box.
O. To the throttle body assembly (fuel pipe)
2-50
CABLE ROUTING