Yamaha SR400 2014 Service Manual page 75

1. Fuel tank
2. Fuel hose (fuel tank–fuel pump case)
3. Fuel cock
4. Fuel sender
5. Fuel tank breather hose 2
6. Clamp
7. Rollover valve
8. Fuel tank breather hose 1
9. Tank stopper
10. Damper
11. Pump case breather hose (fuel pump case–fuel
tank)
12. Fuel hose (fuel pump–fuel rail)
13. Fuel rail
A. The fuel tank breather hose 1 may be passed
through the inside of the fuel tank flange.
B. Point the end of the clamp upward.
C. Point the end of the clamp rearward.
D. Fasten the plug with the plastic locking tie at the
recessed portion that is the fourth from the hose
mounting side
E. Point the end of the plastic locking tie downward
and do not cut off an excess end.
F. Insert the fuel tank breather hose 2 into the base
of the plug.
G. Point the open end of the clamp to the right.
H. Insert the fuel tank breather hose 2 into the base
of the rollover valve.
I. Insert the fuel tank breather hose 1 into the base
of the rollover valve.
J. Install the fuel tank breather hose 1 so that its
white paint mark is located at the fuel tank side.
K. Point the open end of the clamp rearward.
L. Route the fuel tank breather hose 1 to the front of
the damper and tank stopper.
M. Insert the fuel hose (fuel tank–fuel pump case)
into the base of the fuel cock.
N. Install the fuel sender lead to face the inside of the
vehicle.
O. 5 mm (0.20 in)
P. Insert the fuel tank breather hose 1 into an end of
the round portion.
Q. Install the clamp to the position indicated by a
white paint mark on the fuel tank breather hose 1.
2-48
CABLE ROUTING