Yamaha SR400 2014 Service Manual page 152

MASTER CYLINDER" on page 4-28.
EWA13720
WARNING
Make sure the throttle grip operates smooth-
ly.
TIP
The mating surfaces of the right handlebar
switch should be perpendicular to the mating
surfaces of the master cylinder holder.
5. Install:
• Lever holder "1"
TIP
Align the mating surfaces of the lever holder with
the punch mark "a" on the handlebar.
6. Install:
• Left handlebar switch
TIP
During installation, bring the projection of the left
handlebar switch into contact with the lever hold-
er.
7. Install:
• Handlebar grip
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Slightly coat the handlebar left end with a rub-
ber adhesive.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
2
1
3
1
a
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
8. Install:
• Clutch cable "1"
• Decompression cable "2"
TIP
Apply lithium-soap-based grease to the end of
the cable before installation.
1
2
9. Adjust:
• Clutch lever free play
Refer to "ADJUSTING THE CLUTCH LEVER
FREE PLAY" on page 3-10.
Clutch lever free play
5.0–10.0 mm (0.20–0.39 in)
10.Adjust:
• Throttle grip free play
Refer to "CHECKING THE THROTTLE
GRIP" on page 3-24.
Throttle grip free play
3.0–5.0 mm (0.12–0.20 in)
11.Adjust:
• Decompression lever free play
Refer to "ADJUSTING THE DECOMPRES-
SION LEVER FREE PLAY" on page 3-11.
Decompression lever free play
(decompression lever end)
5.0–10.0 mm (0.20–0.39 in)
4-36
HANDLEBAR