Yamaha SR400 2014 Service Manual page 69

1. Rear brake light switch lead
2. Fuse box
3. Rear left turn signal light lead
4. Tail/brake light lead
5. Rear right turn signal light lead
6. Joint coupler
7. Battery lead
8. Hook-and-loop fastener 1
9. Hook-and-loop fastener 2
A. Route the rear brake light switch lead to the rear of
the air filter case.
B. Firmly insert the fuse box into the stay of the
frame.
C. Fasten the tail/brake light lead, rear left turn signal
light lead, and rear right turn signal light lead with
the clamp. Fasten the leads to avoid overlap with
one another.
D. Fasten the rear right turn signal light lead with the
clamp. (Two locations)
E. Fasten the tail/brake light lead, rear left turn signal
light lead, and rear right turn signal light lead with
the plastic locking tie. The plastic locking tie
should be located just in front of the clamp and the
end of the plastic locking tie should point toward
the inside of the vehicle. At this time, avoid slack of
the rear left turn signal light lead and rear right turn
signal light lead.
F. Place the three tail/brake light connectors, two rear
left turn signal light connectors, and two rear right
turn signal light connectors in the protector.
G. After connecting the battery lead to the battery ter-
minal, fasten the battery lead with the clamp.
H. Put the wire harness into the groove of the pump
case box.
2-42
CABLE ROUTING