Yamaha SR400 2014 Service Manual page 81

1. Fuel tank
2. Fuel hose (pressure regulator–fuel tank)
3. Pressure regulator
4. Air filter case
5. Battery box
6. Oil separator
7. Air filter case drain hose
8. Oil hose 2
9. Breather hose
10. Clamp
11. Stator coil assembly lead
12. Crankcase
A. Dispose the fuel hose (pressure regulator–fuel
tank) below the frame.
B. Point the end of the clamp toward the outside of
the vehicle.
C. 10.0 mm (0.39 in)
D. 0–3.0 mm (0–0.12 in)
E. Align the oil separator and crankcase marks with
each other.
F. Fasten the sidestand switch lead and stator coil
assembly lead with the clamp.
G. Fasten the air filter case drain hose with the clamp.
H. Route the air filter case drain hose between the
muffler chamber and the frame.
I. Make sure that the fuel hose (pressure regula-
tor–fuel tank) is located as shown in the illustra-
tion.
2-54
CABLE ROUTING