Configuring Routing Between Mce And Pe - HP 12500 Series Configuration Manual

To do...
Enter IPv6 address family view
Configure the MCE as the eBGP
peer
Redistribute the IGP routes of the
VPN

Configuring routing between MCE and PE

MCE-PE routing configuration includes these tasks:
Bind the MCE-PE interfaces to IPv6 VPN instances
•
• Perform routing configurations
Redistribute IPv6 VPN routes into the routing protocol running between the MCE and the PE.
•
NOTE:
Configurations in this section are configured on the MCE. Configurations on the PE are similar to those on
the PE in common IPv6 MPLS L3VPN network solutions (see
Configuring IPv6 static routing between MCE and PE
To configure IPv6 static routing between MCE and PE:
To do...
Enter system view
Configure static
routes for an IPv6
VPN instance
Configure the
default precedence
for IPv6 static
routes
Configuring RIPng between MCE and PE
To configure RIPng between MCE and PE:
To do...
Enter system view
Use the command...
ipv6-family
peer ipv6-address as-number
as-number
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
Use the command...
system-view
ipv6 route-static ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name nexthop-address } [ preference
preference-value ]
ipv6 route-static vpn-instance s-vpn-instance-name&<1-6>
ipv6-address prefix-length { interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address } [ preference
preference-value ]
ipv6 route-static default-preference default-preference-value
Use the command...
system-view
"Configuring routing between PE and
355
Remarks
—
Required
Optional
By default, no route redistribution
is configured.
A VPN site must advertise the IPv6
VPN network addresses it can
reach to the connected MCE.
Remarks
—
Required
User either
command.
Optional
60 by default
Remarks
—
CE").