HP 12500 Series Configuration Manual page 269
Mpls, routing switch series
Hide thumbs
Also See for 12500 Series:
- Configuration manual (338 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
[PE2] ip vpn-instance vpn2
[PE2-vpn-instance-vpn2] route-distinguisher 200:2
[PE2-vpn-instance-vpn2] vpn-target 222:2
[PE2-vpn-instance-vpn2] quit
[PE2] interface vlan-interface 11
[PE2-Vlan-interface11] ip binding vpn-instance vpn1
[PE2-Vlan-interface11] ip address 10.3.1.2 24
[PE2-Vlan-interface11] quit
[PE2] interface vlan-interface 13
[PE2-Vlan-interface13] ip binding vpn-instance vpn2
[PE2-Vlan-interface13] ip address 10.4.1.2 24
[PE2-Vlan-interface13] quit
# Configure IP addresses for the CEs as per in
After completing the configurations, issue the display ip vpn-instance command on the PEs to view
the configuration of the VPN instances. Use the ping command to test connectivity between the PEs
and their attached CEs. The PEs can ping their attached CEs. Take PE 1 and CE 1 as examples:
[PE1] display ip vpn-instance
Total VPN-Instances configured : 2
VPN-Instance Name
vpn1
vpn2
[PE1] ping -vpn-instance vpn1 10.1.1.1
PING 10.1.1.1: 56
Reply from 10.1.1.1: bytes=56 Sequence=1 ttl=255 time=56 ms
Reply from 10.1.1.1: bytes=56 Sequence=2 ttl=255 time=4 ms
Reply from 10.1.1.1: bytes=56 Sequence=3 ttl=255 time=4 ms
Reply from 10.1.1.1: bytes=56 Sequence=4 ttl=255 time=52 ms
Reply from 10.1.1.1: bytes=56 Sequence=5 ttl=255 time=3 ms
--- 10.1.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 3/23/56 ms
Establish iBGP peer relationships between PEs and CEs to redistribute VPN routes, and configure
4.
routing policies to change the next hop of the routes.
# On CE 1, configure PE 1 as the iBGP peer, and configure a routing policy for the routes received
from PE 1, changing the next hop address of the routes to the IP address of PE 1.
<CE1> system-view
[CE1] route-policy ce-ibgp permit node 0
[CE1-route-policy] apply ip-address next-hop 10.1.1.2
[CE1-route-policy] quit
[CE1] bgp 100
[CE1-bgp] peer 10.1.1.2 as-number 100
[CE1-bgp] peer 10.1.1.2 route-policy ce-ibgp import
[CE1-bgp] import-route direct
[CE1-bgp] quit
RD
100:1
100:2
data bytes, press CTRL_C to break
261
Figure
67. (Details not shown)
Create time
2009/01/22 13:02:21
2009/01/22 13:02:40
Advertisement
Table of Contents
Troubleshooting
