HP 12500 Series Configuration Manual page 286

Figure 70 Network diagram
Device
PE 1
ASBR-PE 1
Configuration procedure
Configure PE 1.
1.
# Run IS-IS on PE 1.
<PE1> system-view
[PE1] isis 1
[PE1-isis-1] network-entity 10.1111.1111.1111.1111.00
[PE1-isis-1] quit
# Configure LSR ID, enable MPLS and LDP.
[PE1] mpls lsr-id 2.2.2.9
[PE1] mpls
[PE1-mpls] quit
[PE1] mpls ldp
[PE1-mpls-ldp] quit
# Configure interface VLAN-interface 2, start IS-IS and enable MPLS and LDP on the interface.
[PE1] interface vlan-interface 2
[PE1-Vlan-interface2] ip address 1.1.1.2 255.0.0.0
[PE1-Vlan-interface2] isis enable 1
[PE1-Vlan-interface2] mpls
[PE1-Vlan-interface2] mpls ldp
[PE1-Vlan-interface2] quit
Interface IP address
Loop0 2.2.2.9/32
Vlan-int1 30.0.0.1/8
Vlan-int2 1.1.1.2/8
Loop0 3.3.3.9/32
Vlan-int1 1.1.1.1/8
Vlan-int2 11.0.0.2/8
Device
PE 2
ASBR-PE 2
278
Interface IP address
Loop0 5.5.5.9/32
Vlan-int1 20.0.0.1/8
Vlan-int2 9.1.1.2/8
Loop0 4.4.4.9/32
Vlan-int1 9.1.1.1/8
Vlan-int2 11.0.0.1/8