HP 12500 Series Configuration Manual page 93

0 input error
0 packets output,
0 output error
Perform the display mpls te tunnel command on each switch to verify information about the MPLS
TE tunnel.
[SwitchA] display mpls te tunnel
LSP-Id Destination
1.1.1.1:1 3.3.3.3
[SwitchB] display mpls te tunnel
LSP-Id Destination
- -
[SwitchC] display mpls te tunnel
LSP-Id Destination
- -
Perform the display mpls lsp command or the display mpls static-cr-lsp command on each switch
to verify information about the static CR-LSP.
[SwitchA] display mpls lsp
-------------------------------------------------------------------
LSP Information: STATIC CRLSP
-------------------------------------------------------------------
FEC In/Out Label
3.3.3.3/32 NULL/20
[SwitchB] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP
------------------------------------------------------------------
FEC In/Out Label
-/- 20/30
[SwitchC] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP
------------------------------------------------------------------
FEC In/Out Label
-/- 30/NULL
[SwitchA] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC
Tunnel0 3.3.3.3/32
[SwitchB] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC
Tunnel0 -/-
[SwitchC] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC
Tunnel0 -/-
0 bytes
In/Out-If
-/Vlan1
In/Out-If
Vlan1/Vlan2
In/Out-If
Vlan2/-
In/Out IF
-/Vlan1
In/Out IF
Vlan1/Vlan2
In/Out IF
Vlan1/-
I/O Label I/O If
NULL/20 -/Vlan1
I/O Label I/O If
20/30 Vlan1/Vlan2
I/O Label I/O If
30/NULL Vlan2/-
85
Name
Tunnel0
Name
Tunnel0
Name
Tunnel0
Vrf Name
Vrf Name
Vrf Name
State
Up
State
Up
State
Up