Sending Back Icmp Ttl Exceeded Messages For Mpls Ttl Expired Packets - HP 12500 Series Configuration Manual

Figure 11 Label TTL processing when IP TTL propagation is disabled
To configure IP TTL propagation of MPLS:
To do...
Enter system view
Enter MPLS view
Enable MPLS IP TTL propagation
CAUTION:
Within an MPLS domain, TTL is always copied between multiple levels of labels. The ttl propagate
•
command affects only the propagation of the IP TTL to the TTL of an MPLS label. Therefore, this
command takes effect only when it is configured on the ingress.
• For locally generated packets, an LSR always copies the IP TTL value of the packet, regardless of whether
IP TTL propagation is enabled or not. This makes sure that the local administrator can tracert for network
diagnoses.
If you enable MPLS IP TTL propagation for VPN packets on one LSR, you also need to enable it on all
•
related provider edge (PE) devices, so that you can get the same result when you traceroute from those
PEs. For more information about PE, see the chapter "Configuring MPLS L3VPN."
Sending back ICMP TTL exceeded messages for MPLS TTL
expired packets
After you enable an LSR to send back ICMP TTL exceeded messages for MPLS TTL expired packets, when
the LSR receives an MPLS packet that carries a label with TTL being 1, it will generate an ICMP TTL
exceeded message, and send the message to the packet sender in one of the following ways:
• If the LSR has a route to the packet sender, it sends the ICMP TTL exceeded message to the packet
sender directly through the IP route.
If the LSR has no route to the packet sender, it forwards the ICMP TTL exceeded message along the
•
LSP to the egress, which will send the message to the packet sender.
Usually, for an MPLS packet carrying only one level of label, the first method is used; for an MPLS packet
carrying a multi-level label stack, the second method is used. However, because autonomous system
boundary routers (ASBRs), superstratum PEs or service provider-end PEs (SPEs) in Hierarchy of VPN
(HoVPN) applications, and carrier backbone PEs in nested VPNs may receive MPLS VPN packets that
carry only one level of labels but these devices have no IP routes to the packet senders, the first method
Use the command...
system-view
mpls
ttl propagate { public | vpn }
22
Remarks
—
—
Optional
Enabled for only public network
packets by default