HP 12500 Series Configuration Manual page 187

To do...
Specify the PW transport mode
Specify the tunneling policy
Return to system view
Configure the remote peer
Enter the view of the interface
connecting the CE
Create a service instance and
enter service instance view
Configure a packet matching rule
for the service instance
Create a Martini MPLS L2VPN
connection based on Layer 2
Ethernet interface and VLAN
Display information about one or
all service instances configured on
the interface
Use the command...
trans-mode { ethernet | vlan }
pw-tunnel-policy policy-name
quit
mpls ldp remote-peer
remote-peer-name
remote-ip ip-address
interface interface-type
interface-number
service-instance service-instance-id
encapsulation { s-vid vlan-id
[ only-tagged ] | port-based |
tagged | untagged }
xconnect peer peer-ip-address
pw-id pw-id [ access-mode
{ ethernet | vlan } | mtu mtu-value
| [ pw-class class-name ] ] *
display service-instance interface
interface-type interface-number
[ service-instance instance-id ] [ |
{ begin | exclude | include }
regular-expression ]
179
Remarks
Optional
VLAN by default
Optional
By default, the default tunneling
policy is used. The default
tunneling policy selects only one
tunnel in this order: LSP tunnel,
CR-LSP tunnel.
For how to configure a tunneling
policy, see the chapter
"Configuring MPLS L3VPN."
—
Required
Required
—
Required
By default, no service instance is
created.
Required
By default, no packet matching
rule is configured for a service
instance.
For this configuration task, do not
specify the only-tagged,
port-based, tagged, and untagged
keywords. Otherwise, the packet
matching rule configuration will
not take effect.
Required
After this command is executed,
the VLAN ID, access mode, and
MTU configured for the service
instance cannot be changed. To
modify these parameters, you
need to use the undo xconnect
peer command to remove the
L2VPN connection first.
Available in any view