HP 12500 Series Configuration Manual page 263

[PE1-bgp] quit
NOTE:
The configurations for PE 2 are similar to those for PE 1. (Details not shown)
After you complete the configuration, issue the display bgp vpnv4 vpn-instance peer command on
the PEs. You will see that BGP peer relationships have been established between PEs and CEs, and
have reached Established state. Take PE 1 for example:
[PE1] display bgp vpnv4 vpn-instance vpn1 peer
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1
Peer AS
10.1.1.1 65410
Configure MP-iBGP peers between PEs.
5.
# Configure PE 1.
[PE1] bgp 100
[PE1-bgp] peer 3.3.3.9 as-number 100
[PE1-bgp] peer 3.3.3.9 connect-interface loopback 0
[PE1-bgp] ipv4-family vpnv4
[PE1-bgp-af-vpnv4] peer 3.3.3.9 enable
[PE1-bgp-af-vpnv4] quit
[PE1-bgp] quit
# Configure PE 2.
[PE2] bgp 100
[PE2-bgp] peer 1.1.1.9 as-number 100
[PE2-bgp] peer 1.1.1.9 connect-interface loopback 0
[PE2-bgp] ipv4-family vpnv4
[PE2-bgp-af-vpnv4] peer 1.1.1.9 enable
[PE2-bgp-af-vpnv4] quit
[PE2-bgp] quit
After you complete the configuration, issue the display bgp peer command or the display bgp
vpnv4 all peer command on the PEs. You will see that a BGP peer relationship in Established state
has been established between the PEs. Take PE 1 for example:
[PE1] display bgp peer
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1
Peer AS
3.3.3.9 100
Verify your configuration.
6.
Issue the display ip routing-table vpn-instance command on the PEs. You will see the routes to the
CEs. The following takes PE 1 as an example:
[PE1] display ip routing-table vpn-instance vpn1
Routing Tables: vpn1
Destinations : 5
MsgRcvd MsgSent OutQ
11 9
MsgRcvd MsgSent
2 6
Routes : 5
255
Peers in established state : 1
PrefRcv Up/Down
0 1 00:06:37
Peers in established state : 1
OutQ PrefRcv Up/Down
0 0 00:00:12 Established
State
Established
State