MPLS TE configuration task list
Complete the following tasks to configure MPLS TE:
Task
Configuring MPLS TE basic settings
Configuring an
MPLS TE tunnel
Configuring RSVP-TE advanced features
Tuning CR-LSP setup
Tuning MPLS TE tunnel setup
Configuring traffic forwarding
Configuring traffic forwarding tuning parameters
Configuring CR-LSP backup
Configuring FRR
Inspecting an MPLS TE tunnel
Configuring protection switching
Configuring MPLS TE basic settings
This configuration task includes the basic settings required for all MPLS TE features.
Configuration prerequisites
Before you configure MPLS TE basic settings, complete the following tasks:
Configure static routing or IGPs to make sure all LSRs are reachable.
•
•
Configure basic MPLS.
NOTE:
For configuration information about MPLS basic settings, see the chapter "Configuring basic MPLS."
Configuration procedure
To configure MPLS TE basic settings:
To do...
Enter system view
Enter MPLS view
Creating MPLS TE tunnel over static CR-LSP
Configuring MPLS TE tunnel with dynamic signaling protocol
Use the command...
system-view
mpls
Forwarding traffic along MPLS TE tunnels
using static routes
Forwarding traffic along MPLS TE tunnels
through automatic route advertisement
52
Remarks
Required
Required
Use either approach
Optional
Optional
Optional
Required
Use any approach
Optional
Optional
Optional
Optional
Optional
Remarks
––
––