Configuring Routing Between Mce And Vpn Site - HP 12500 Series Configuration Manual

Configuring routing between MCE and VPN site

Configuring static routing betweem MCE and VPN site
An MCE can reach a VPN site through a static route. Static routing on a traditional CE is globally
effective and thus does not support address overlapping among VPNs. An MCE supports binding a static
route with a VPN instance, so that the static routes of different VPN instances can be isolated from each
other.
To configure static routing between MCE and VPN site:
To do...
Enter system view
Configure static routes for a
VPN instance
Configure the default
precedence for static routes
Configuring RIP between MCE and VPN site
A RIP process belongs to the public network or a single VPN instance. If you create a RIP process without
binding it to a VPN instance, the process belongs to the public network. By configuring RIP
process-to-VPN instance bindings on a MCE, you allow routes of different VPNs to be exchanged
between the MCE and the sites through different RIP processes, ensuring the separation and security of
VPN routes.
To configure RIP between MCE and VPN site:
To do...
Enter system view
Create a RIP process for a VPN
instance and enter RIP view
Enable RIP on the interface
attached to the specified network
Redistribute remote site routes
advertised by the PE
Use the command...
system-view
ip route-static dest-address { mask | mask-length }
{ gateway-address | interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address } [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
ip route-static vpn-instance
s-vpn-instance-name&<1-6> dest-address { mask |
mask-length } { gateway-address [ public ] |
interface-type interface-number [ gateway-address ] |
vpn-instance d-vpn-instance-name gateway-address }
[ preference preference-value ] [ tag tag-value ]
[ description description-text ]
ip route-static default-preference
default-preference-value
Use the command...
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name |
tag tag ] *
236
Remarks
—
Required
Use either command.
Perform this
configuration on the
MCE. On a VPN site,
configure a normal
static route.
Optional
60 by default
Remarks
—
Required
Perform this configuration on the
MCE. On a VPN site, create a
normal RIP process.
Required
By default, RIP is disabled on an
interface.
Required
By default, no route is redistributed
into RIP.