Configuring Ldp Gr - HP 12500 Series Configuration Manual

is not applicable. In this case, you can configure the undo ttl expiration pop command on these devices
so that the devices use the second method.
NOTE:
For more information about HoVPN and nested VPN, see the chapter "Configuring MPLS L3VPN."
To configure the switch to send back an ICMP TTL exceeded message for a received MPLS TTL expired
packet:
To do...
Enter system view
Enter MPLS view
Enable the switch to send back an
ICMP TTL exceeded message when
it receives an MPLS TTL expired
packet
Specify that ICMP TTL exceeded
messages for MPLS packets with
only one-level of label travel along
the IP routes
Specify that ICMP TTL exceeded
messages for MPLS packets with
only one-level of label travel along
the LSPs

Configuring LDP GR

MPLS has two separate planes: the forwarding plane and the control plane. Using this feature, LDP
Graceful Restart (GR) preserves the LFIB information when the signaling protocol or control plane fails, so
that LSRs can still forward packets according to LFIB, ensuring continuous data transmission.
A switch that participates in a GR process plays either of the following two roles:
GR restarter, the switch that gracefully restarts due to a manually configured command or a fault. It
•
must be GR-capable.
GR helper, neighbor of the GR restarter. A GR helper maintains the neighbor relationship with the
•
GR restarter and helps the GR restarter restore its LFIB information. A GR helper must be
GR-capable.
Use the command...
system-view
mpls
ttl expiration enable
ttl expiration pop
undo ttl expiration pop
23
Remarks
—
—
Optional
Enabled by default.
Optional
Configure one of them as required.
By default, ICMP TTL exceeded
messages for MPLS packets with
only one-level of label travel along
the local IP routes.
This configuration does not take
effect when the MPLS packets carry
multiple levels of labels. ICMP TTL
exceeded messages for such MPLS
packets always travel along the
LSPs.