Mpls Te Using Rsvp-Te Configuration Example - HP 12500 Series Configuration Manual

NOTE:
On an MPLS TE tunnel configured using a static CR-LSP, traffic is forwarded directly based on label at the
transit nodes and egress node. Therefore, it is normal that the FEC field in the sample output is empty on
Switch B and Switch C.
Create a static route for routing MPLS TE tunnel traffic.
7.
[SwitchA] ip route-static 3.2.1.2 24 tunnel 0 preference 1
Perform the display ip routing-table command on Switch A. You can see a static route entry with
interface Tunnel 0 as the outgoing interface.

MPLS TE using RSVP-TE configuration example

Network requirements
Switch A, Switch B, Switch C, and Switch D are running IS-IS and all of them are Level-2 devices.
Use RSVP-TE to create a TE tunnel with 2000 kbps of bandwidth from Switch A to Switch D
Figure 21 Network diagram
Device
Switch A
Switch B
Configuration procedure
Assign IP addresses and masks to interfaces (see
1.
Details not shown
Enable IS-IS to advertise host routes with LSR IDs as destinations.
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] network-entity 00.0005.0000.0000.0001.00
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] isis enable 1
Interface IP address
Loop0 1.1.1.9/32
Vlan-int1 10.1.1.1/24
Loop0 2.2.2.9/32
Vlan-int1 10.1.1.2/24
Vlan-int2 20.1.1.1/24
Device Interface
Switch D Loop0
Vlan-int3
Switch C Loop0
Vlan-int3
Vlan-int2
Figure 21).
86
IP address
4.4.4.9/32
30.1.1.2/24
3.3.3.9/32
30.1.1.1/24
20.1.1.2/24