HP 12500 Series Configuration Manual page 360

Configuring RIPng between MCE and VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different VPNs
to be exchanged between the MCE and the sites through different RIPng processes, ensuring the
separation and security of IPv6 VPN routes.
To configure RIPng between MCE and VPN site:
To do...
Enter system view
Create a RIPng process for a VPN
instance and enter RIPng view
Redistribute remote site routes
advertised by the PE
Configure the default cost value for
the redistributed routes
Return to system view
Enter interface view
Enable RIPng on the interface
NOTE:
For more information about RIPng, see
Configuring OSPFv3 between MCE and VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
IPv6 VPNs to be exchanged between the MCE and the sites through different OSPFv3 processes,
ensuring the separation and security of IPv6 VPN routes.
To configure OSPFv3 between MCE and VPN site:
To do...
Enter system view
Create an OSPFv3 process for a
VPN instance and enter OSPFv3
view
Set the router ID
Use the command...
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
default cost value
quit
interface interface-type
interface-number
ripng process-id enable
Layer 3—IP Routing Configuration Guide
Use the command...
system-view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
router-id router-id
352
Remarks
—
Required
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
Required
By default, no route of any other
routing protocol is redistributed
into RIPng.
Optional
0 by default
—
—
Required
Disabled by default
.
Remarks
—
Required
Perform this configuration on the
MCE. On a VPN site, configure
normal OSPFv3.
Required