HP 12500 Series Configuration Manual page 130

In-Label
Out-Label
In-Interface
Out-Interface
LspIndex
Tunnel ID
LsrType
Outgoing Tunnel ID
Label Operation
No
VrfIndex
Fec
Nexthop
In-Label
Out-Label
In-Interface
Out-Interface
LspIndex
Tunnel ID
LsrType
Outgoing Tunnel ID
Label Operation
Perform the display interface tunnel command on PE 1. The output shows that traffic is being
forwarded along the CR-LSP of the TE tunnel.
[PE1] display interface tunnel 1
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 1500
Internet Address is 12.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
34 packets input,
0 input error
34 packets output,
0 output error
: 3
: NULL
: Vlan-interface2
: ----------
: 10241
: 0x0
: Egress
: 0x0
: POP
: 4
:
: 3.3.3.3/32
: 10.0.0.2
: NULL
: 3
: ----------
: Vlan-interface2
: 10242
0x22000
: Ingress
: 0x0
: PUSH
5 bytes/sec, 0 packets/sec
5 bytes/sec, 0 packets/sec
2856 bytes
2856 bytes
122
0/100/0
0/500/0
0/75/0