HP 12500 Series Configuration Manual page 117

Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
Perform the display mpls te tunnel-interface command on Switch A to verify the configuration of
the tunnel interface.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel Desc
Tunnel State Desc
Tunnel Attributes
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
Class Type
Reserved BW
Setup Priority
Affinity Prop/Mask
Explicit Path Name
Tie-Breaking Policy :
Metric Type
Record Route
FRR Flag
BackUpBW Type
Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
Min BW
Current Collected BW:
Interfaces Protected:
VPN Bind Type
VPN Bind Value
Car Policy
Tunnel Group
Primary Tunnel
Backup Tunnel
Group Status
Configure a bypass tunnel on Switch B (the PLR).
5.
# Create an explicit path for the bypass LSP.
[SwitchB] explicit-path by-path
[SwitchB-explicit-path-by-path] next hop 3.2.1.2
[SwitchB-explicit-path-by-path] next hop 3.3.1.2
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
: Tunnel4
: Tunnel4 Interface
: CR-LSP is Up
:
: 1.1.1.1:1
: 10
: UP
: 1.1.1.1
: RSVP
: CT0
: 0 kbps
: 7
: 0/0
: pri-path
None
: None
: Enabled
: Enabled
: -
: Disabled
: 10
: Disabled
: None
: -
: Disabled
: -
-
-
: NONE
: -
: Disabled
: Primary
: -
: -
: -
109
Oper State : UP
Egress LSR ID: 4.4.4.4
Resv Style : SE
Tunnel BW : 0 kbps
Hold Priority: 7
Record Label : Enabled
BackUpBW Flag: Not Supported
BackUpBW : -
Retry Interval: 10 sec
Reopt Freq : -
Auto BW Freq : -
Max BW : -