HP 12500 Series Configuration Manual page 268
Mpls, routing switch series
Hide thumbs
Also See for 12500 Series:
- Configuration manual (338 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
[PE2-Vlan-interface12] quit
After you complete the configuration, P establishes an LDP session with PE 1 and PE 2, respectively.
Issue the display mpls ldp session command. The output shows that the session status is
Operational. Issue the display mpls ldp lsp command. The output shows the LSPs established by
LDP. Take PE 1 as an example:
[PE1] display mpls ldp session
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID
---------------------------------------------------------------
2.2.2.9:0
---------------------------------------------------------------
LAM : Label Advertisement Mode
[PE1] display mpls ldp lsp
------------------------------------------------------------------
SN
DestAddress/Mask
------------------------------------------------------------------
1
1.1.1.9/32
2
2.2.2.9/32
3
3.3.3.9/32
------------------------------------------------------------------
A '*' before an LSP means the LSP is not established
A '*' before a Label means the USCB or DSCB is stale
Configure VPN instances on PEs to allow CEs to access.
3.
# Configure PE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 111:1
[PE1-vpn-instance-vpn1] quit
[PE1] ip vpn-instance vpn2
[PE1-vpn-instance-vpn2] route-distinguisher 100:2
[PE1-vpn-instance-vpn2] vpn-target 222:2
[PE1-vpn-instance-vpn2] quit
[PE1] interface vlan-interface 11
[PE1-Vlan-interface11] ip binding vpn-instance vpn1
[PE1-Vlan-interface11] ip address 10.1.1.2 24
[PE1-Vlan-interface11] quit
[PE1] interface vlan-interface 12
[PE1-Vlan-interface12] ip binding vpn-instance vpn2
[PE1-Vlan-interface12] ip address 10.2.1.2 24
[PE1-Vlan-interface12] quit
# Configure PE 2.
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 200:1
[PE2-vpn-instance-vpn1] vpn-target 111:1
[PE2-vpn-instance-vpn1] quit
LDP Session(s) in Public Network
Status
LAM
Operational
DU
LDP LSP Information
In/OutLabel
3/NULL
NULL/3
NULL/1024
260
SsnRole
FT
MD5
Passive
Off
Off
FT
: Fault Tolerance
Next-Hop
In/Out-Interface
127.0.0.1
-------/InLoop0
172.1.1.2
-------/Vlan-interface13
172.1.1.2
-------/Vlan-interface13
KA-Sent/Rcv
5/5
Advertisement
Table of Contents
Troubleshooting
