Current Batch; General Information - JUMO mTRON T Operating Manual

7.8

Current batch

7.8.1

General information

Using the multifunction panel, nine different batches (batch reports) can be recorded and reg-
istered in parallel. In the visualization, a distinction is made between a "current batch" and the
last "completed batch". The number of batch reports used and the text in the batch visualization
can be configured on the multifunction panel or using the setup program.
(1) Batch start/batch end
(3) Batch status
(5) Communication status
(7) Batch rotation
Batch start/batch end
If the batch start was selected using the touchpad, then the batch reporting is started and ended
by touching the button. If a different type of batch start has been selected, the button is inactive.
NOTE!
There must be at least 5 seconds between the end of a batch (batch end) and the next start
(batch start). A new batch can only be started once this period has elapsed.
Batch texts, "left column"
The texts in the "left column" are predetermined by the configuration and cannot be changed
during batch reporting.
(2)
(1)
7 Visualization
(4)
(3)
(6)
(2) Batch texts, "left column"
(4) Batch texts, "right column"
(6) Batch selection
(8) Home button
(5)
(7) (8)
69