4Diagram View - JUMO mTRON T Operating Manual

13.11.4 Diagram view
Setup dialog
Parameter
NOTE!
Some of the stated parameters can also be changed by touching the
tifunction panel in the "Diagram" or "Digital" visualization.
The advantage of this is that the configuration is not changed.
Parameter
Diagram header
?
Measure. val.
select.
?
Show envel. dia-
gram
?
Show digital
channels
?
Selection/settings
This parameter can be used to switch the diagram header on and off. The diagram
header (numerical display of the measured values and/or switch symbols for digital
channels) are available in the Diagram and Digital visualizations.
No
Yes
Min
Max
No
Yes
This parameter determines whether the digital channels (digital signals) in the dia-
gram display are to be displayed together with the analog signals.
No
Yes
13 Configuration
button on the mul-
Description
Diagram header switched off
Diagram header switched on
The minimum values are displayed in
the diagram header.
The maximum values are displayed in
the diagram header.
The min./max. values are displayed as a
line.
The min./max. values are displayed as
an envelope diagram.
The digital signals are not displayed.
Digital and analog signals are displayed.
157