Finisher; Part Names - Sharp MX-2630N User Manual

BEFORE USING THE MACHINE►PERIPHERAL DEVICES

FINISHER

This device outputs sorted paper while staggering each set of paper. As needed, it staples each set. To punch holes in
printed paper, install an optional hole punch module.

PART NAMES

(1) Output tray (upper tray)
The tray is slidable. To print on large paper such as A3
paper, extend the tray.
(2) Output tray (lower tray)
Stapled and offset output is delivered to this tray.
The tray is slidable. To print on large paper such as A3
paper, extend the tray.
• To install a finisher, a paper pass unit and stand/550/2x550/3x550/550&2100 sheet paper drawer are required.
• A finisher cannot be installed simultaneously with an inner finisher, finisher (large stacker), saddle stitch finisher or saddle
stitch finisher (large stacker).
• Do not place heavy objects on the finisher or press down on the finisher.
• Exercise caution when you turn on the power and when printing take place, as the tray may move up and down.
(1) (2) (3)
(4)
1-116
(3) Top cover
Open this cover to remove a paper misfeed.
(4) Front cover
Open this cover to replace the staple cartridge or remove
a staple jam.