Polycom VS4000 Administrator's Manual page 68

Administrator's Guide for ViewStation EX, ViewStation FX, and VS4000
3-20
To configure Broadcast Mode settings:
1. Go to System Info > Admin Setup > Video Network > Video Network and
enable Broadcast Mode.
2. Select Broadcast Mode Setup and configure these settings:
Setting Description
Video Format Specifies the resolution at which video is transmitted.
Video Protocol Specifies the protocol used to transmit video. Choose the lowest
protocol supported by all systems in the conference.
Audio Mode Specifies the protocol used to transmit audio,
Frame Rate Specifies the frame rate to use.
In Broadcast Mode, the system sends and receives audio and video without handshaking
with the far end systems. This enables the system to send transmissions to many systems
at once, such as satellite networks. In this mode, the system does not receive audio and
video from all far site systems.
To select dialing speeds:
1. Go to System Info > Admin Setup > Video Network and enable RS-366
Dialing.
Select Dialing Speeds and select the call rates that users can choose for making
2.
calls.
• Nx56 and Nx64 rates are available for ISDN calls.
• IPx56 and IPx64 rates are available for IP calls.
www.polycom.com/videodocumentation