Polycom VSX Series Administrator's Manual page 176

Administrator's Guide for the VSX Series
Status Tools
Diagnostic Tool
Content Statistics screen
Displays content format, data rate,
frame rate, and packet loss for the
call in progress. Also provides
information about the far site
systems.
Call Detail Report screen
Displays the current Call Detail
Report (CDR) and provides access
to the archived CDR.
Network Tools
Diagnostic Tool
Enable Basic Mode
Enables a limited operating mode
that uses H.261 for video and G.711
for audio. This mode provides
administrators with a work-around
for interoperability issues that
cannot be solved using other
methods. The Basic Mode setting
stays in effect until you change it.
Near End Loop test
Tests the internal audio encoders
and decoders, the external
microphones and speakers, the
internal video encoders and
decoders, and the external cameras
and monitors.
Monitor 1 displays the video and
plays the audio that would be sent
to the far site in a call.
This test is not available when you
are in a call.
7 - 4
In the system's user interface
1. On the Diagnostics screen,
select Call Statistics.
2. Select three times to go to
the Content Statistics screen.
Not available.
For more information about this screen, see
page 6-4.
In the system's user interface
Go to System > Admin Settings >
Network > Call Preference and
select Enable Basic Mode.
1. On the Diagnostics screen,
select Network.
2. Select Near End Loop to start
the test.
3. Press any button on the remote
control to stop the test.
In the VSX Web
Not available.
Select Utilities > Call Detail
Report.
Call Detail Report (CDR)
In the VSX Web
1. Select Admin Settings >
Network > Call Preference >
Call Preference.
2. Select Enable Basic Mode.
1. Select Diagnostics > Network
> Near End Loop.
2. Click Near End Loop to start
the test.
3. Click Near End Loop again to
end the test.
on