AudioCodes Mediant 800B User Manual page 1016

Parameter
Web: Add NPI and TON to
Redirect Number
CLI: np-n-ton-2-redirnb
[AddNPIandTON2RedirectNu
mber]
Web: IP to Tel Remove
Routing Table Prefix
EMS: Remove Prefix
CLI: ip2tel-rmv-rte-tbl
[RemovePrefix]
Web/EMS: Swap Redirect and
Called Numbers
CLI: swap-rdr-n-called-nb
[SwapRedirectNumber]
[UseReferredByForCallingNu
mber]
[SwapTel2IPCalled&Calling
Numbers]
Web/EMS: Add Prefix to
Redirect Number
CLI: add-pref-to-redir-nb
[Prefix2RedirectNumber]
User's Manual
Determines whether the NPI and TON values are added as the prefix
to the Redirect number in INVITE messages' Diversion or History-
Info headers, for ISDN Tel-to-IP calls.

[0] Yes (Default)

[1] No
Determines whether or not the device removes the prefix (as
configured in the Inbound IP Routing table - see ''Configuring
Inbound IP Routing Table'' on page 421) from the destination
number for IP-to-Tel calls, before sending it to the Tel.

[0] No (default)

[1] Yes
For example: To route an incoming IP-to-Tel call with destination
number "21100", the Inbound IP Routing table is scanned for a
matching prefix. If such a prefix is found (e.g., "21"), then before the
call is routed to the corresponding Trunk Group, the prefix "21" is
removed from the original number, and therefore, only "100"
remains.
Notes:

This parameter is applicable only if number manipulation is
performed after call routing for IP-to-Tel calls (i.e.,
RouteModeIP2Tel parameter is set to 0).

Similar operation (of removing the prefix) is also achieved by
using the usual number manipulation rules.

[0] No = (Default) Don't change numbers.

[1] Yes = Incoming ISDN call that includes a redirect number
(sometimes referred to as 'original called number') uses the
redirect number instead of the called number.
Determines whether the device uses the number from the URI in the
SIP Referred-By header as the calling number in the outgoing Q.931
Setup message, when SIP REFER messages are received.

[0] = (Default) No

[1] = Yes
Notes:

This parameter is applicable to all ISDN (TBCT, RLT, ECT) and
CAS blind call transfers (except for in-band) and when the device
receives SIP REFER messages with a Referred-By header.

This manipulation is done before regular IP-to-Tel source number
manipulation.
Determines whether the device swaps the calling and called
numbers received from the Tel side (for Tel-to-IP calls). The SIP
INVITE message contains the swapped numbers.

[0] = (Default) Disabled

[1] = Swap calling and called numbers
Note: This parameter can also be configured for a Tel Profile (in the
Tel Profile table).
Defines a string prefix that is added to the Redirect number received
from the Tel side. This prefix is added to the Redirect Number in the
SIP Diversion header.
The valid range is an 8-character string. By default, no value is
defined.
1016
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10620