Ipv4-Based Vrrp Configuration Examples; Single Vrrp Group Configuration Example - H3C S9500E Series Configuration Manual

To do...
3. Clear VRRP group statistics

IPv4-based VRRP configuration examples

By default, Ethernet interfaces, VLAN interfaces, and aggregate interfaces are in the DOWN state. To
configure such an interface, use the undo shutdown command to bring it up first.

Single VRRP group configuration example

Network requirements
•
Host A needs to access Host B on the Internet, using 202.38.160.111/24 as its default
gateway.
•
Switch A and Switch B belong to VRRP group 1 with the virtual IP address of
202.38.160.111/24.
•
If Switch A operates normally, packets sent from Host A to Host B are forwarded by Switch
A; if Switch A fails, packets sent from Host A to Host B are forwarded by Switch B.
Figure 30 Network diagram for single VRRP group configuration
202.38.160.3/24
Host A
Configuration procedure
Configure Switch A
1.
Use the command...
reset vrrp ipv6 statistics [ interface
interface-type interface-number [ vrid virtual-
router-id ] ]
Virtual IP address:
202.38.160.111/24
Vlan-int2
202.38.160.1/24
Switch A
Vlan-int2
202.38.160.2/24
Switch B
132
203.2.3.1/24
Internet
Host B
Remarks
Available in user
view