Configuring Rrpp Nodes - H3C S9500E Series Configuration Manual

Configuring RRPP nodes

The maximum number of rings that can be configured on a switch in all RRPP domains is 16 total.
•
If a switch carries multiple RRPP rings in an RRPP domain, only one ring can be configured as the
•
primary ring on the switch and the role of the switch on a subring can only be an edge node or an
assistant-edge node.
Specifying a master node
Perform this configuration on a switch to be configured as a master node.
To specify a master node:
To do...
1. Enter system view
2. Enter RRPP domain view
3. Specify the current switch as
the master node of the ring,
and specify the primary port
and the secondary port
Specifying a transit node
Perform this configuration on a switch to be configured as a transit node.
To specify a transit node:
To do...
1. Enter system view
2. Enter RRPP domain view
3. Specify the current switch as a
transit node of the ring, and
specify the primary port and
the secondary port
Specifying an edge node
When configuring an edge node, you must configure the primary ring before configuring
subrings.
Perform this configuration on a switch to be configured as an edge node.
Use the command...
system-view
rrpp domain domain-id
ring ring-id node-mode master [
primary-port interface-type interface-
number ] [ secondary-port interface-type
interface-number ] level level-value
Use the command...
system-view
rrpp domain domain-id
ring ring-id node-mode transit [
primary-port interface-type interface-
number ] [ secondary-port interface-type
interface-number ] level level-value
61
Remarks
—
—
Required
Remarks
—
—
Required