Activating An Rrpp Domain - H3C S9500E Series Configuration Manual

To specify an edge node:
To do...
1. Enter system view
2. Enter RRPP domain view
3. Specify the current switch as a
transit node of the primary
ring, and specify the primary
port and the secondary port
4. Specify the current switch as
the edge node of a subring,
and specify the edge port
Specifying an assistant-edge node
When configuring an assistant-edge node, you must configure the primary ring before
configuring subrings.
Perform this configuration on a switch to be configured as an assistant-edge node.
To specify an assistant-edge node:
To do...
1. Enter system view
2. Enter RRPP domain view
3. Specify the current switch as a
transit node of the primary
ring, and specify the primary
port and the secondary port
4. Specify the current switch as
the assistant-edge node of the
subring, and specify an edge
port

Activating an RRPP domain

To activate an RRPP domain on the current switch, enable the RRPP protocol and RRPP rings for
the RRPP domain on the current switch.
Perform this task on all nodes in the RRPP domain.
To activate an RRPP domain:
To do...
1. Enter system view
Use the command...
system-view
rrpp domain domain-id
ring ring-id node-mode transit [
primary-port interface-type interface-
number ] [ secondary-port interface-type
interface-number ] level level-value
ring ring-id node-mode edge [ edge-
port interface-type interface-number ]
Use the command...
system-view
rrpp domain domain-id
ring ring-id node-mode transit [
primary-port interface-type interface-
number ] [ secondary-port interface-type
interface-number ] level level-value
ring ring-id node-mode assistant-
edge [ edge-port interface-type
interface-number ]
Use the command...
system-view
62
Remarks
—
—
Required
Required
Remarks
—
—
Required
Required
Remarks
—