H3C S9500E Series Configuration Manual page 187

[SwitchA] nqa schedule admin test start-time now lifetime forever
Configure a track entry on Switch A
4.
Configure track entry 1, and associate it with Reaction entry 1 of the NQA test group (with the
administrator admin, and the operation tag test).
[SwitchA] track 1 nqa entry admin test reaction 1
Configure VRRP on Switch A
5.
Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
Set the priority of Switch A in VRRP group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.
[SwitchA-Vlan-interface2] vrrp vrid 1 authentication-mode simple hello
Configure the master to send VRRP packets at an interval of five seconds.
[SwitchA-Vlan-interface2] vrrp vrid 1 timer advertise 5
Configure Switch A to work in preemptive mode, and set the preemption delay to five seconds.
[SwitchA-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5
Configure to monitor track entry 1 and set the priority decrement to 30.
[SwitchA-Vlan-interface2] vrrp vrid 1 track 1 reduced 30
Configure VRRP on Switch B
6.
<SwitchB> system-view
[SwitchB] interface vlan-interface 2
Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.
[SwitchB-Vlan-interface2] vrrp vrid 1 authentication-mode simple hello
Configure the master to send VRRP packets at an interval of five seconds.
[SwitchB-Vlan-interface2] vrrp vrid 1 timer advertise 5
Configure Switch B to work in preemptive mode, and set the preemption delay to five seconds.
[SwitchB-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5
Verify the configuration
7.
After configuration, ping Host B on Host A, and you can see that Host B is reachable. Use the
display vrrp command to view the configuration result.
Display detailed information about VRRP group 1 on Switch A.
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
: Standard
: Virtual MAC
187