H3C S9500E Series Configuration Manual page 202

Figure 51 Network diagram for VRRP-track-interface management collaboration configuration
10.1.1.3/24
Host A
Configuration procedure
Create VLANs, and assign IP addresses to VLAN interfaces, as shown in Figure 51. (Details
1.
not shown.)
Add ports to related VLANs. (Details not shown.)
2.
Configure a track entry on Switch A.
3.
Configure track entry 1, and associate it with the physical status of the uplink interface VLAN-
interface 3.
[SwitchA] track 1 interface vlan-interface 3
Configure VRRP on Switch A.
4.
Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
Set the priority of Switch A in VRRP group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
Configure to monitor track entry 1 and specify the priority decrement as 30.
[SwitchA-Vlan-interface2] vrrp vrid 1 track 1 reduced 30
Configure VRRP on Switch B.
5.
<SwitchB> system-view
[SwitchB] interface vlan-interface 2
Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
Verify the configuration
6.
After configuration, ping Host B on Host A, and you can see that Host B is reachable. Use the
display vrrp command to view the configuration result.
Virtual IP address:
10.1.1.10/24
Vlan-int2 Vlan-int3
10.1.1.1/24 10.1.2.1/24
10.1.2.2/24
Switch A
Vlan-int3
Vlan-int2
10.1.3.1/24
10.1.1.2/24
10.1.3.2/24
Switch B
202
Vlan-int3
Switch C
Internet
Vlan-int3
Switch D
20.1.1.1/24
Host B