Configuring Protected Vlans; Configuring Rrpp Rings - H3C S9500E Series Configuration Manual

To do...
1. Enter system view
2. Enter RRPP domain view
3. Specify the primary control
VLAN for the RRPP domain
To ensure proper forwarding of RRPPDUs, do not enable QinQ or VLAN mapping on the control VLANs.
•
To ensure that RRPPDUs can be sent and received correctly, do not configure the default VLAN of a port
•
accessing an RRPP ring as the primary control VLAN or the secondary control VLAN.
To transparently transmit RRPPDUs on a switch not configured with RRPP, you must ensure that only the
•
two ports connecting the switch to the RRPP ring permit packets of the control VLANs. Otherwise, the
packets from other VLANs may go into the control VLANs in transparent transmission mode and strike
the RRPP ring.

Configuring protected VLANs

Before configuring RRPP rings in an RRPP domain, configure the same protected VLANs for all
nodes in the RRPP domain first. All VLANs that the RRPP ports are assigned to should be protected
by the RRPP domains.
Perform this configuration on all nodes in the RRPP domain to be configured.
To configure protected VLANs:
To do...
1. Enter system view
2. Enter RRPP domain view
3. Configure protected
VLANs for the RRPP
domain
When configuring load balancing, ensure that the protected VLANs configured for different RRPP domains
are different.

Configuring RRPP rings

Use the command...
system-view
rrpp domain domain-id
control-vlan vlan-id
Use the command...
system-view
rrpp domain domain-id
protected-vlan reference-
instance instance-id-list
59
Remarks
—
—
Required
Remarks
—
—
Required
By default, no protected VLAN is
configured for an RRPP domain.