H3C S9500E Series Configuration Manual page 159

Figure 37 Network diagram for VRRP load balancing mode
Configuration procedure
Configure Switch A
1.
Configure VLAN 2.
<SwitchA> system-view
[SwitchA] vlan 2
[SwitchA-vlan2] port Gigabitethernet 3/0/5
[SwitchA-vlan2] quit
Configure VRRP to work in load balancing mode.
[SwitchA] vrrp mode load-balance
Create VRRP group 1 and configure its virtual IPv6 address as FE80::10.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ipv6 address fe80::1 link-local
[SwitchA-Vlan-interface2] ipv6 address 1::1 64
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
Set the priority of Switch A in VRRP group 1 to 120.
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 priority 120
Set Switch A to work in preemptive mode. The preemption delay is five seconds.
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode timer delay 5
159