Creating An Rrpp Domain; Configuring Control Vlans - H3C S9500E Series Configuration Manual

Task
Configuring RRPP timers
Configuring RRPP fast
detection
Configuring an RRPP ring group
RRPP does not have an auto election mechanism, so you must configure each node in the ring network
•
properly for RRPP to monitor and protect the ring network.
Before configuring RRPP, you must construct a ring-shaped Ethernet topology physically.
•

Creating an RRPP domain

To assign a switch to an RRPP domain, you must create the RRPP domain on the switch. This must
be done on all switches you want to assign to the RRPP domain.
Perform this configuration on all nodes that you want to assign to the RRPP domain.
To create an RRPP domain:
To do...
1. Enter system view
2. Create an RRPP domain and enter
RRPP domain view

Configuring control VLANs

Before configuring RRPP rings in an RRPP domain, configure the same control VLANs for all nodes
in the RRPP domain first.
Perform this configuration on all nodes in the RRPP domain to be configured.
To configure control VLANs:
Remarks
Optional
Perform this task on the master node in the RRPP domain.
Optional
Enabling fast
Perform this task on the master node, edge node, and
detection
assistant-edge node in the RRPP domain.
Optional
Configuring fast
detection timers
Perform this task on the master node in the RRPP domain.
Optional
Perform this task on the edge node and assistant-edge node in
the RRPP domain.
Use the command...
system-view
rrpp domain domain-id
58
Remarks
—
Required
Once the RRPP domain is
created, the switch is
assigned to the RRPP domain.