H3C S9500E Series Configuration Manual page 191

Create track entry 1 to be associated with the BFD session to check whether Switch A is
reachable.
[SwitchB] track 1 bfd echo interface vlan-interface 2 remote ip 192.168.0.101
local ip 192.168.0.102
Configure VRRP on Switch B
6.
Create VRRP group 1, and configure the virtual IP address 192.168.0.10 for the group. VRRP
group 1 monitors the status of track entry 1. When the status of the track entry becomes
Negative, Switch B quickly becomes the master.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 192.168.0.10
[SwitchB-Vlan-interface2] vrrp vrid 1 track 1 switchover
[SwitchB-Vlan-interface2] return
Verify the configuration
7.
Display the detailed information of VRRP group 1 on Switch A.
<SwitchA> display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
Display the detailed information of VRRP group 1 on Switch B.
<SwitchB> display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
: Standard
: Virtual MAC
: 1
: Up
: 110
: Yes
: None
: 192.168.0.10
: 0000-5e00-0101
: 192.168.0.101
: Standard
: Virtual MAC
: 1
: Up
: 100
: Yes
: None
191
Adver Timer : 1
State : Master
Running Pri : 110
Delay Time : 0
Adver Timer : 1
State : Backup
Ru nning Pri : 100
Delay Time : 0