Power Off The Server Module (Power Button - Standby Mode) - Sun Oracle SPARC T3-1B Service Manual

Jun 28 13:06:34 dt90-366 syslogd: going down on signal 15
svc.startd: The system is down.
syncing file systems... done
Program terminated
SPARC T3-1B, No Keyboard
OpenBoot 4.30, 16256 MB memory available, Serial # 87305111.
Ethernet address 0:21:28:34:2b:90, Host ID: 85342b90.
{0} ok
6. Switch from the system console to the -> prompt by typing the #. (Hash
Period) key sequence.
7. At the -> prompt, type:
->stop /SYS
Note – You can also use the Power button on the front of the server module to
initiate a graceful shutdown. (See
Standby Mode)" on page
module power-off. Use the tip of a pen or other stylus to operate this button.
Related Information
"Power Off the Server Module (Power Button - Standby Mode)" on page 57
■
"Power Off the Server Module (Emergency Shutdown)" on page 58
■
"Prepare the Server Module for Removal" on page 58
■
▼ Power Off the Server Module (Power Button -
Standby Mode)
This procedure places the server module in the power standby mode. In this mode,
the Power OK LED blinks rapidly.
●
Press and release the recessed Power button.
Use a stylus or the tip of a pen to operate this button. See
Components" on page
Related Information
"Shut Down the Oracle Solaris OS" on page 56
■
"Power Off the Server Module (Emergency Shutdown)" on page 58
■
"Power Off the Server Module (Power Button -
57. This button is recessed to prevent accidental server
2.
"Front and Rear Panel
Preparing for Service 57