Clear Faults (Clear_Fault_Action Property); Service-Related Oracle Ilom Command Summary - Sun Oracle SPARC T3-1B Service Manual

▼ Clear Faults (clear_fault_action Property)

Use the clear_fault_action property with the set command to manually clear
PSH-detected faults for a FRU.
If Oracle ILOM detects a FRU replacement, it will automatically clear the fault so that
you do not have to clear the fault manually. For PSH-diagnosed faults, if the
replacement of the FRU is detected by the system or the fault is manually cleared on
the host, the fault will also be cleared from Oracle ILOM. In such cases, you typically
do not have to clear the fault manually.
Note – This procedure clears the fault from the SP but not from the host. If the fault
persists in the host, clear it manually as described in
page 30.
●
At the -> prompt, use the set command with the clear_fault_action=True
property.
Example:
-> set /SYS/MB/CMP0/BOB0/CH0/D0 clear_fault_action=True
Are you sure you want to clear /SYS/MB/CMP0/BOB0/CH0/D0 (y/n)? y
Set 'clear_fault_action' to 'true'
Related Information
"Diagnostics Process" on page 7
■
"Access the SP (Oracle ILOM)" on page 15
■
"Display FRU Information (show Command)" on page 17
■
"Check for Faults (show faulty Command)" on page 18
■
"Check for Faults (fmadm faulty Command)" on page 20
■
"Service-Related Oracle ILOM Command Summary" on page 21
■

Service-Related Oracle ILOM Command Summary

The following table describes the Oracle ILOM shell commands most frequently used
when performing service-related tasks.
"Clear PSH-Detected Faults" on
Detecting and Managing Faults 21