Display System Components - Sun Oracle SPARC T3-1B Service Manual

The following ASR commands enable you to view and add or remove components
(asrkeys) from the ASR blacklist. You run these commands from the Oracle ILOM
-> prompt.
TABLE:
Command
show components
set asrkey component_state=
Enabled
set asrkey component_state=
Disabled
Note – The asrkey values vary from system to system, depending on how many
cores and memory are present. Use the show components command to see the
asrkey values on a given system.
After you enable or disable a component, you must reset (or power cycle) the system
for the component's change of state to take effect. See the SPARC T3 Series Servers
Administration Guide
Related Information
"Display System Components" on page 45
■
"Disable System Components" on page 47
■
"Enable System Components" on page 48
■

▼ Display System Components

The show components command displays the system components (asrkeys) and
reports their status.
●
At the -> prompt, type the show components command.
In the following example, one of the DIMMs (BOB1/CH0/D0) is shown as
disabled.
->show components
Target
--------------------+------------------------+-------------------------------
/SYS/MB/REM
ASR Commands
| Property
| component_state
Description
Displays system components and their current state.
Removes a component from the asr-db blacklist,
where asrkey is the component to enable.
Adds a component to the asr-db blacklist, where
asrkey is the component to disable.
| Value
| Enabled
Detecting and Managing Faults 45